"Alarm is on" Light

[Hendrik W. M. van Eeden]

On 8/23/05 12:57 PM, "Jerry"  wrote:

> I was thinking about putting an LED on the front, garage door, and
> two rear sliding glass doors, letting myself and others know that an
> alarm is armed.  Anyone else done this and have any suggestions on
> how to approach this?  I'm assuming that an appliance module,
> transformer, and running wires to LEDs will work?  Is this going to
> burn out a transformer switching it on and off like this?
> 
> Any direction would be appreciated!
> 
> Jp
I have used a dry contact from my Alarm System to feed a Power Flash module
that can be set for flashing or steady on.  Its address is set to a X-10
wall wart .  The wall wart then powers what ever your want  The flashing
signal goes over the power line, which may not be what you want.
-- 
Henk